I am facing a problem in RH 7.3 based distro. I just install it on a machine which have two Sun HME ethernet cards. But it wont detect my card. Few time before I installed it on same machine and it detects both cards normaly but now I dont know why it wont detect them. So I manually loaded there modules and make desired aliases in /etc/modules.conf
Now I am able to configure these interfaces via ifconfig command but cant let them down or up via ifup and ifdown command. Even I cant able to load (active) them at boot time. I tried to make ifcfg-eth0 and ifcfg-eth1 in /etc/sysconfig/network-scripts but cant load them boot time any way to fix this prob.
Discussion regarding the installation and configuration of Linux distributions.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest