X-Server Problume

ubaidkt · Post by **ubaidkt** » Thu Jun 16, 2005 6:24 am

Salam
During installation if I select Wrong model of monitor then linux X-Server dos'nt start, its go to CLI. it also dose not go in X with command startx. plz help me how i correct the monitor type?.

fadain · Post by **fadain** » Thu Jun 16, 2005 2:19 pm

Edit your /etc/X11/xorg.conf. Go to the 'Monitor Section' and then change HorizSync and VertRefresh accordingly. Here's mine

Code: Select all

Section "Monitor"
    Identifier  "Viewsonic171s"
    HorizSync   30-82
    VertRefresh 50-85

Post by **LinuxFreaK** » Fri Jun 17, 2005 12:14 am

Dear ubaidkt,
Salam,

ubaidkt wrote:During installation if I select Wrong model of monitor then linux X-Server dos'nt start, its go to CLI. it also dose not go in X with command startx. plz help me how i correct the monitor type?.

if you are using Red Hat Linux then type this command

# redhat-config-xfree86

Best Regards.

saquib_javed · Post by **saquib_javed** » Fri Jun 17, 2005 5:53 pm

also check ddcprobe

linuxpakistan.net

X-Server Problume

X-Server Problume

Re: X-Server Problume