problem in Scanner e+48u

Discussion regarding the installation and configuration of Linux distributions.
Posts: 61
Joined: Tue May 06, 2003 5:46 pm
Location: UK (Lahore, Pakistan)

problem in Scanner e+48u

Postby mwalam » Thu Oct 02, 2003 5:07 am

i am using Mandrake 9.1. Now my scanner is shown compatable in Sane web site with Backends. It shows this message when i go to Mandrake Control Centre < Hardware < Scanner.

The following scanner

- Artec E+ 48U USB flatbed scanner

is available on your system.
But the Xsane does not come to know that scanner is attached. Please help me in to configure this scanner. I shall be very thankkful to you. Please help me in it.[/b]

Site Admin
Posts: 5132
Joined: Fri May 02, 2003 10:24 am
Location: Karachi


Postby LinuxFreaK » Thu Oct 02, 2003 5:21 am

Dear mwalam,

Tell me did You have the sane drivers installed? Did you install the sane-backends package? Did you also mount the device? Do you have a /dev/usb/scanner0 ? If all the above Questions Answers are Yes then All I have to say is look over ... ation.html and see if you're missing any of that.

Best Regards
Farrukh Ahmed

Return to “Installation”

Who is online

Users browsing this forum: No registered users and 2 guests