problem in Scanner e+48u

Discussion regarding the installation and configuration of Linux distributions.

problem in Scanner e+48u

Postby mwalam » Thu Oct 02, 2003 5:07 am

i am using Mandrake 9.1. Now my scanner is shown compatable in Sane web site with Backends. It shows this message when i go to Mandrake Control Centre < Hardware < Scanner.

The following scanner

- Artec E+ 48U USB flatbed scanner

is available on your system.
.
But the Xsane does not come to know that scanner is attached. Please help me in to configure this scanner. I shall be very thankkful to you. Please help me in it.[/b]
Waqas
mwalam
Naik
 
Posts: 61
Joined: Tue May 06, 2003 5:46 pm
Website: http://www.geocities.com/Muhammad.html
WLM: Waqas a good boy
Location: UK (Lahore, Pakistan)

Re:

Postby LinuxFreaK » Thu Oct 02, 2003 5:21 am

Dear mwalam,
Salam,

Tell me did You have the sane drivers installed? Did you install the sane-backends package? Did you also mount the device? Do you have a /dev/usb/scanner0 ? If all the above Questions Answers are Yes then All I have to say is look over http://www.angelfire.com/linux/crapsite ... ation.html and see if you're missing any of that.

Best Regards
Farrukh Ahmed
LinuxFreaK
Site Admin
 
Posts: 5132
Joined: Fri May 02, 2003 10:24 am
ICQ: 82075802
Website: http://www.linuxpakistan.net/wiki/index.php?pagename=LinuxFreak
WLM: f4fahmed@hotmail.com
Yahoo Messenger: f4fahmed@yahoo.com
AOL: linuxpakistan@aol.com
Location: Karachi


Return to “%s” Installation

Who is online

Users browsing this forum: No registered users and 1 guest

cron