linux modem problem

Discussion regarding the installation and configuration of Linux distributions.
nomi4214

linux modem problem

Postby nomi4214 » Fri Oct 04, 2002 7:16 pm

I m using zoltrix smart cobra lite modem.
i have installed its driver successfully
it is connecting fine
modem connecting to isp
but no data go in and out
browser does not work
but still connected
can any one help me this issue

nomi4214

modem issue important

Postby nomi4214 » Sat Oct 05, 2002 2:04 am

My problem is now changed.
I got pci-modem and pci-lancard(3com) on my computer.
When i deactivate Pci-lancard then modem works properly.
but When I activate lancard then modem connected to internet but
no data transmit in or out no browser works
can anybody solve this issue
please reply me
As soon as possible on
nomi4214@yahoo.com

farhanksa
Subedar
Posts: 359
Joined: Sun Nov 03, 2002 6:40 am
Location: Lahore
Contact:

pls check the IRQ and mem i/o

Postby farhanksa » Sun Dec 29, 2002 7:46 pm

pls check the IRQ and mem i/o
run kudzu after removing a lan card
then again activate the modem and then configure both after checking the irq and mem i/o

farhanksa
Subedar
Posts: 359
Joined: Sun Nov 03, 2002 6:40 am
Location: Lahore
Contact:

configure modem or lan card at a time

Postby farhanksa » Mon Dec 30, 2002 4:13 am

aoa

well try to configure the modem from the shell.do u know ??ttys? u r using and then wvdail.conf

then try to config the eth? from the shell. configuration from the gui some time dont work well
god luck
aoa

Aadil
Naik
Posts: 60
Joined: Fri Dec 27, 2002 10:36 pm
Contact:

Postby Aadil » Tue Dec 31, 2002 5:23 am

Double check the ports and irq's/Dma settings for the two hardware.Confirm that they are on different ports.Maybe you specified one port to both and now they conflict.

linuxgeek
Site Admin
Posts: 195
Joined: Wed Aug 07, 2002 8:00 pm
Location: Multan, Pakistan
Contact:

Linux Modem - Network Card Problem

Postby linuxgeek » Mon Mar 31, 2003 3:41 pm

Assalam O Alaikum There,

The problem is not with the irq or anything ig uess... it basically lies with the routing ... when you enable the lan card , eht0 in my case , it basically becomes the default gateway and route ..and thats why when you try to browse with ur lan card activated it will actually route the data from the lan card instead of the modem ...... hmmms the solution to this is that you can change the priority of the routes in Redhat Network Config .... menu , if you are using RH 8.0 .. lemme know if you couldnt find it .. i will give u a link to some graphical help.!

Regards
Junaid Saeed Uppal
uppal at linux dot net dot pk
Cell : +92.345.8586045


Return to “Installation”

Who is online

Users browsing this forum: No registered users and 1 guest