Monitor bandwidth usage by pool or VLAN

Share your expert knowledge and show off your skills.

Monitor bandwidth usage by pool or VLAN

Postby southworth » Fri Jun 22, 2007 8:39 pm

If you're a NetEqualizer user and would like see the amount of bandwidth usage (instantaneous usage) in a pool, simply use the following command in the command line:

brctl getpeak my <pool#>

To see the amount of bandwidth usage (instantaneous usage) on a VLAN, you will first need to set up a VLAN shaping rule on the NetEqualizer to make it VLAN aware. From the command line, you’ll then type:

brctl getpeak my <VLAN_ID + 50000>

That should do it.
southworth
Cadet
 
Posts: 4
Joined: Fri Jun 22, 2007 8:03 pm

Return to “%s” Howto's & Tip n' Tricks

Who is online

Users browsing this forum: No registered users and 1 guest

cron