I m using zoltrix smart cobra lite modem.
i have installed its driver successfully
it is connecting fine
modem connecting to isp
but no data go in and out
browser does not work
but still connected
can any one help me this issue
linux modem problem
modem issue important
My problem is now changed.
I got pci-modem and pci-lancard(3com) on my computer.
When i deactivate Pci-lancard then modem works properly.
but When I activate lancard then modem connected to internet but
no data transmit in or out no browser works
can anybody solve this issue
please reply me
As soon as possible on
nomi4214@yahoo.com
I got pci-modem and pci-lancard(3com) on my computer.
When i deactivate Pci-lancard then modem works properly.
but When I activate lancard then modem connected to internet but
no data transmit in or out no browser works
can anybody solve this issue
please reply me
As soon as possible on
nomi4214@yahoo.com
pls check the IRQ and mem i/o
pls check the IRQ and mem i/o
run kudzu after removing a lan card
then again activate the modem and then configure both after checking the irq and mem i/o
run kudzu after removing a lan card
then again activate the modem and then configure both after checking the irq and mem i/o
configure modem or lan card at a time
aoa
well try to configure the modem from the shell.do u know ??ttys? u r using and then wvdail.conf
then try to config the eth? from the shell. configuration from the gui some time dont work well
god luck
aoa
well try to configure the modem from the shell.do u know ??ttys? u r using and then wvdail.conf
then try to config the eth? from the shell. configuration from the gui some time dont work well
god luck
aoa
-
- Site Admin
- Posts: 195
- Joined: Wed Aug 07, 2002 8:00 pm
- Location: Multan, Pakistan
- Contact:
Linux Modem - Network Card Problem
Assalam O Alaikum There,
The problem is not with the irq or anything ig uess... it basically lies with the routing ... when you enable the lan card , eht0 in my case , it basically becomes the default gateway and route ..and thats why when you try to browse with ur lan card activated it will actually route the data from the lan card instead of the modem ...... hmmms the solution to this is that you can change the priority of the routes in Redhat Network Config .... menu , if you are using RH 8.0 .. lemme know if you couldnt find it .. i will give u a link to some graphical help.!
Regards
The problem is not with the irq or anything ig uess... it basically lies with the routing ... when you enable the lan card , eht0 in my case , it basically becomes the default gateway and route ..and thats why when you try to browse with ur lan card activated it will actually route the data from the lan card instead of the modem ...... hmmms the solution to this is that you can change the priority of the routes in Redhat Network Config .... menu , if you are using RH 8.0 .. lemme know if you couldnt find it .. i will give u a link to some graphical help.!
Regards
Junaid Saeed Uppal
uppal at linux dot net dot pk
Cell : +92.345.8586045
uppal at linux dot net dot pk
Cell : +92.345.8586045