H323 trunk to SIP problem (asterisk)

Taking care of your Linux box.
Post Reply
syedbilalmasaud
Naib Subedar
Posts: 347
Joined: Thu Aug 18, 2005 9:25 am
Location: Attock
Contact:

H323 trunk to SIP problem (asterisk)

Post by syedbilalmasaud »

Dear All,

I am trying to configure H323 Trunk on freePBX , first of all freepbx is not supported with h323 properly means it will not listen on 1720(H323 port) unless I will install OOh323 and recompile asterisk , but when I will recompile , systems starts working on h323 but once installation is done , I have following problems

1:- SIP users stop registering to asterisk , (I can see packets are arriving to system but asterisk says that id and pass are incorrect , which is 100% correct)
2:- When I will receive call from H323 trunk and transfer it to SIP , no voice connectivity
3:- Call is coming from Cisco Access Server AS53xx , which is only supported for H323 , In this stage I cannot change or update IOS because I dont want to change IOS just for small change and I am pretty sure that H323 and SIP should work ,I am doing some thing SILLY

any Ideas , I am sure that someone must have tried this kind of stuff on asterisk

Call Flow

Cisco AS5350 (123456) toll free number ==> H323 ==> Asterisk ==> 123456,s,1,Dial(SIP/100,25,tT)

Am I doing some thing wrong ?

Thanks


Cheers:)
Bilal
Cheers :)

:D B I L A L :D
kbukhari
Major General
Posts: 1222
Joined: Sat Dec 31, 2005 12:29 am
Location: Lahore
Contact:

Re: H323 trunk to SIP problem (asterisk)

Post by kbukhari »

syedbilalmasaud wrote:Dear All,

I am trying to configure H323 Trunk on freePBX , first of all freepbx is not supported with h323 properly means it will not listen on 1720(H323 port) unless I will install OOh323 and recompile asterisk , but when I will recompile , systems starts working on h323 but once installation is done , I have following problems
i will recomend you not to use freepbx use asterisk on command line
1:- SIP users stop registering to asterisk , (I can see packets are arriving to system but asterisk says that id and pass are incorrect , which is 100% correct)
check output of " asterisk -rx 'sip show peers'
2:- When I will receive call from H323 trunk and transfer it to SIP , no voice connectivity

need more discriptions
3:- Call is coming from Cisco Access Server AS53xx , which is only supported for H323 , In this stage I cannot change or update IOS because I dont want to change IOS just for small change and I am pretty sure that H323 and SIP should work ,I am doing some thing SILLY
why not?
--
Syed Kashif Ali Bukhari
+92-345-8444420
http://sysadminsline.com
http://kashifbukhari.com
syedbilalmasaud
Naib Subedar
Posts: 347
Joined: Thu Aug 18, 2005 9:25 am
Location: Attock
Contact:

Post by syedbilalmasaud »

ok let me do the following

I will install asterisk on command line maually with h323 support and see how it works

for SIP registration asterisk just says bad auth
which is correct and i am 100% sure
Cheers :)

:D B I L A L :D
LinuxFreaK
Site Admin
Posts: 5132
Joined: Fri May 02, 2003 10:24 am
Location: Karachi
Contact:

Re:

Post by LinuxFreaK »

Dear syedbilalmasaud,
Salam,
syedbilalmasaud wrote:for SIP registration asterisk just says bad auth
which is correct and i am 100% sure
Show your /etc/asterisk/sip.conf

Best Regards.
Farrukh Ahmed
Post Reply